Chemforce Stain Protector 5L

• Stain Protector™ gives optimal stain protection by providing superior water and oil repellence.
• Stain Protector™ is suitable for most types of porous building materials, including: Natural stone, brick, terracotta, concrete paving and polished concrete.
• Stain Protector™ is suitable for indoor and outdoor surfaces, including: Floors, patios, kitchens, bathrooms, terraces, entertaining areas and pool surrounds (use Fortifier Plus for salt-water pool surrounds).
• Super-penetrating, permanent bonding technology for superior protection against efflorescence, picture framing, salt spalling, freeze-thaw spalling.
• Retains surface colour, finish and slip resistance if applied correctly.
• On outdoor surfaces, including natural stone, Stain Protector™ provides a very deep hydrophobic (water repellent) barrier which keeps water out of the pores near the surface of the material and reduces mould growth.
• Highly breathable, allows water vapor to escape freely, and limits harmful moisture buildup inside the treated material.
• Stain Protector™ is highly UV resistant, chemical resistant and heat resistant and stands up to commercial cleaning methods.
• Treated surfaces remain to look good for longer and are easier to clean.
• IMPORTANT: Chemforce™ is an Australian owned company with high quality labs and manufacturing factories and Stain Protector™ was developed and manufactured in our facilities in Sunshine West, Victoria, Australia

Application:

1. Leave to penetrate for at least 10 minutes.
2. Generously apply STAIN-PROTECTOR^™ using low pressure hand sprayer, brush or microfiber / wool applicator. Very porous surfaces should have a mirror like wet look for at least 3-5 seconds. Avoid contact with surrounding areas.
3. Before it dries on the surface, apply a second generous coat.
4. Total application rate (for both coats combine) is one litre per 4 to 20 sqm (one gallon per 160 to 800 sq. ft) depending on surface absorption.
5. After minimum 10 minutes but, before the second coat dries, thoroughly polish the surface with clean, white absorbent cotton or microfiber towels (or similar) to remove ALL product residue. If residue has begun to dry, moistening a cloth with Stain Protector™ to ease removal.
6. Use an organic solvent e.g. alcohol or mineral spirits to clean equipment.
7. Avoid moisture contact with the surface for six hours after application.

NOTE: Sealer will NOT prevent surface etching, scuff marks or mechanical wear and may lighten or darken some surfaces. Stain Protector™ repels water and oil, but not solvents, so solvent based materials, such as marking pen ink can still stain the treated surface, but will penetrate less, and be easier to remove. All spills should be cleaned up immediately to minimize absorption.